
Steel Abrasive Blasting
Abrasive preparation of steel to the specified cleanliness and profile, on site or at our Austral workshop.
Learn moreIndustrial abrasive blasting, remedial surface preparation, protective coatings and decorative finishes across Sydney. On-site and in-house capability with inspection support for specified coating work.
Steel structures, equipment and plant prepared for specified coating systems, on site or at our Austral workshop.
Exposed aggregate, coating removal and stencil artwork across suitable concrete, timber and brickwork.
CIP inspectors can support agreed hold points, measurement and reporting for coating projects.
Explore our services below. We work on site and at our Austral facility, selecting the preparation and finish to suit the project.

Abrasive preparation of steel to the specified cleanliness and profile, on site or at our Austral workshop.
Learn more
Specified industrial coating systems with controlled preparation, application and inspection.
Learn more
Localised mechanical steel preparation followed by controlled brush and roller coating application.
Learn more
Project-specific coating inspection, ITP hold points and documented checks through preparation, application and handover.
Learn more
Internal surface preparation and protective coating for suitable tanks, vessels and enclosed assets, with project-specific entry planning and inspection.
Learn more
Workshop abrasive blasting and protective coating of suitable transportable items at Austral, from preparation through inspection and collection.
Learn more
Exposed aggregate finishes, coating removal and abrasive preparation of concrete to the specified Concrete Surface Profile (CSP) for coating application.
Learn more
Custom graphics, patterns, lettering and logos blasted into suitable surfaces using approved stencils.
Learn more
Controlled coating removal and surface preparation for timber ceilings, beams, trusses and architectural features.
Learn more
Sample-led paint removal and surface restoration for brick walls, facades and suitable masonry.
Learn moreA nine-stage process for defined scopes, controlled preparation and coating work, and inspection records where specified. The documents and hold points are scaled to the project.
We review the asset, location, access, existing condition, drawings and any coating specification. A site inspection or photos help define the work and identify constraints.
We set out the proposed preparation method, coating system or finish, inclusions, access, containment, cleanup limits and assumptions in a project-specific quote.
For specified work we prepare a methodology and Safe Work Method Statement, then agree an Inspection and Test Plan with the client. The ITP identifies checks, acceptance criteria, records and hold or witness points.
Before work starts, we confirm site access, isolate the work area as agreed, protect adjacent assets and establish the containment and recovery controls appropriate to the site.
The team checks the substrate, abrasive and equipment. For coating work, specified ambient readings and condensation risk are recorded before preparation or application proceeds.
We blast, wet blast or use power tools to the agreed target. On steel, visual cleanliness and surface profile are checked against the coating specification; decorative surfaces are compared with the agreed sample.
Where included in the ITP, AMPP Coating Inspector Program (CIP) inspectors verify preparation and documented hold points before coating. Any area that does not meet the agreed criteria is addressed and rechecked.
The specified primer, intermediate and finish coats are applied within the manufacturer’s conditions and recoat windows. Edges, welds and corners receive stripe coating where required; wet film thickness is monitored during application.
After cure, agreed visual and dry film thickness checks are completed. We close out records, address defects within scope, demobilise and hand over the inspection package required by the project.
Our coating projects can include agreed inspection and test points with CIP inspectors. The project specification, coating manufacturer data sheets and substrate determine the acceptance criteria. Agreed records may cover abrasive condition, cleanliness, surface profile, climatic readings, stripe coats and coating thickness.
Visual cleanliness, surface profile, ambient conditions, wet film thickness and dry film thickness can be checked and recorded where required by the project ITP.
AMPP CIP Coating InspectionStandards apply to relevant steel and protective coating work. Decorative concrete, timber and masonry finishes are assessed against their project requirements and agreed visual reference.
For a quote, include the surface, approximate size, suburb, desired finish and any photos you have. We can help narrow down the preparation and application method.